Pull out the old switch. The first step is to run the white, ground, and hot wires from the power source to the first switch. Note the black tape (or paint) on the white wires that are used as switched hot instead of neutral.
Wire A Three Way Switch
Best of all, they are easy to install.
Attach The Ground Wires To The Ground Screw By Using Green Hole Wire Nut.
Web connect both white wires, connect 14/2 wire’s black wire to light’s black common screw. The conventions and wire colors are for the u.s.a. With conduit, the wire colors for travelers could be any color.
It’s Likely You’ll Also Need To Replace The.
Turn off the power at the service panel. Match the wires to connect the circuit wires to the fixture. The colors will vary depending on whether nm cable or conduit was used.
Find The Breaker Panel In The Home.
When they are opposite, the circuit opens and there will be no light. Have the black and red wires of 14/3 attach with silver or gold screws. The power source will enter at either the light fixture or at one of the switch boxes.
When The Toggles From Both Switches Are Up Or Down, The Circuit Is Complete And The Light Will Be On.
Web three way switches are used any time two switches are needed to control a light. Tuck those wires nicely and get the switch box installed. It’s likely you’ll also need to replace the.
Turn Off The Correct Circuit At Your Electrical Panel.
Before proceeding, make sure you are comfortable working with electrical wires and switches. The ground wire is pigtailed with a wire connector at the switch boxes and the ceiling box. This presentation shows the internal workings of three ways and how a light.
Remove The Two Screws On The Switch Plate, And Then Remove The Plate To Reveal The Old.
Look for a label next to a breaker.
